How should a concealed safe be installed in the home?

How to install a home concealed safe? Below, the editor from Henan Huadu Times Furniture will explain in detail:

Installation steps for a home concealed safe : Step 1: Wall selection and opening size

I. Selection of Wall Structure and Hole Locations

1. Standard 18cm wall. If the selected wall is smaller than 18cm, please ensure the wall surface is compensated. If it is larger than 18cm, the thickness of the concrete on the north side of the base shell can be increased.

2. It is recommended that the hole be placed 150 cm to 180 cm above the ground. Users can also choose the hole location according to specific circumstances.

II. Wall opening dimensions

1. Horizontal direction > 64.5 cm 2. Vertical direction > 43.5 cm

III. Precautions

1. The drilled holes should be parallel to the ground to avoid tilting.

2. After drilling the hole, the wall's stability can be maintained.

Step 2 of installing a home concealed safe : Installing the bottom shell

1. Select a suitable wall according to "Wall Selection and Opening Size" and prepare the installation hole positions required by the regulations.

2. Pour a layer of concrete about 3-4 cm thick directly below the mounting holes to facilitate adjusting the level of the base shell and integrate the bottom surface of the base shell with the wall.

3. Place the bottom shell in the container, adjust and measure its levelness and verticality to ensure it is placed horizontally and vertically.

4. Pour concrete into the gaps between the base shell and the wall (if the gaps are large, you can first fill them with some bricks or steel bars before pouring the concrete). This step is crucial for the strong bond between the base shell and the wall; the higher the quality of the concrete pouring process, the better the bond.

5. Next, apply concrete directly to the bottom shell wire mesh surface, squeezing the concrete into the wire mesh to integrate it with the bottom shell. This step is crucial for the integration between the bottom shell and the wall; higher quality workmanship results in better outcomes.

6. Wall renovation (painting, tiling, etc.)

7. Clean the inside of the bottom shell, ensuring that both the inside and exposed surfaces of the bottom shell are clean.

Step 3 of installing a home concealed safe : Picture frame installation

1. Push the picture frame open so that the frame and stand are in a completely horizontal position.

2. Align the four gourd holes on the support with the four pins on the bottom shell according to the positions indicated by the arrows.

III. Precautions

1. The bracket and frame must be fully unfolded to expose the four gourd holes before installation.

2. Two people are required to complete the assembly process: one person holds the frame, and the other holds the frame bracket and aligns the holes for installation.

Step 4 of installing a home concealed safe : Installing the safe body

1. Gently and slowly place the box into the bottom shell, ensuring it is properly installed.

Precautions:

1. Before placing the box into the bottom shell, please remove the four silicone plugs.

2. During this installation process, care should be taken to avoid bumping or scratching the enclosure and other components to prevent affecting the appearance.

3. Due to the weight of the box, it must be carefully lifted when placed inside the bottom shell to prevent it from falling and causing injury.

2. Open the cabinet door, remove the four silicone inner plugs, and keep them safe.

Third, use four M10X16 screws to secure the box and bottom shell through the four holes inside the box. Then, insert four silicone plugs into the screw holes.